Some examples and use cases from the internet:

Some examples and use cases from the internet:

• Care shall be exercised to ensure that no exterior downward or lateral loads are applied to the 3
• D H machine.
• Care shall be exercised in holding the T
• Care shall be exercised to ensure that no exterior downward or lateral loads are applied to the 3
• Care shall be exercised to ensure that no exterior downward or lateral loads are applied to the 3
• D H machine.
• Both tractive and compressive test loads are applied on each separate towing device fitted to the vehicle.
• D H machine.

• The 5 daN load applied on the test bench shall be guided vertically in such a way as to prevent the load swaying and the belt twisting.
• There is no need to measure the force and deflection at the point where the load is applied to the structure; however, force and deflection shall be measured simultaneously and co
• The porcelain peg is brought onto the sample under test and the load applied.
• If the vehicle is fitted with a badge, mascot or other structure which would bend back or retract under a low applied load, then such a load shall be applied before and/or while these measurements are taken.
• The vertical plane in which the load is applied shall be located at a distance of one third of the external width of the upper part of the structure from the median plane.
• linearly.
• If the structural member to which the load is to be applied is curved, the specifications laid down in point 2.1.2.5 of Annex II must be complied with.
• When in the secondary latched position, the primary latch system shall not separate when a load of 4500 N is applied in the same direction as in paragraph 6.1.1.1, when tested in accordance with paragraph 7.1.1.1.