Some examples and use cases from the internet:

Some examples and use cases from the internet:

• The flow test must be carried out at an upstream air pressure of 200 kPa absolute, and at temperature of 15 ºC.
• exposure of the material to a pH of more than 11 for more than 3 hours at temperature of more than 80 ºC and subsequently by heat treatment at more than 140 ºC for 30 minutes at more than 3,6 bar; and
• D, if the fuel is at least at temperature of 20 ºC. Otherwise the test shall comprise four phases A
• The test shall comprise of three phases B
• Dry the droplets at ambient temperatures or by warming at temperature of 40 to 45 ºC.
• exposure of the material to a pH of more than 11 for more than 3 hours at temperature of more than 80ºC and subsequently by heat treatment at more than 140ºC for 30 minutes at more than 3.6 bar;
• 95 per cent relative humidity for 168 hours.
• After the spraying the component is stored at temperature of 40 ºC and 90

• Pasteurisation is carried out at a temperature of 72 ºC for 20 seconds.
• The extrusion process takes place at a temperature of 150 ºC.
• Measured at a temperature of 15 ºC.
• Thermostat or other apparatus for keeping the flask at a temperature of 52 ± 2 ºC.
• It is curdled at a temperature of approximately 30 ºC.
• Before each test the pieces or samples shall be stored for four hours at least at a temperature of 23 ± 2 oC.
• The sample unit(s) shall then be immediately immersed in the same conditions in water at a temperature of 25 ± 5 ºC.
• However, those sales descriptions shall only apply to products which remain solid at a temperature of 20 ºC and which are suitable for use as spreads.