Some examples and use cases from the internet:

Some examples and use cases from the internet:

• The hatched area bounded by points 17 to 20 is typically used for footsteps.
• The hatched area bounded by points 4, 5 and 6 is available for wheels, lifeguards, etc. only.
• The force
• If the tests above were performed at a higher speed and/or the deceleration curve has exceeded the upper level of the hatched area and the Child Restraint System meets the requirements, the test shall be considered satisfactory.
• deflection curves fall within the hatched area of Figure 2, Graph 2a.
• However, if the tests above were performed at a higher speed and/or the acceleration curve has exceeded the upper level of the hatched area and the child restraint meets the requirements, the test shall be considered satisfactory.
• deflection of the impactor as a whole shall fall within the hatched area of Figure 2, Graph 2e.
• Their rigidity is such that their force

• And what's this shaded area here?
• The used patch should be placed within the open disposal label so that the sticky surface covers the shaded area on the sachet.
• insulated live part shall not be placed in the shaded area (25 kV).
• No rigid part of the vehicle may project into the shaded area shown on the figure.
• They should be located far enough from the front and rear wall of the vehicle to produce a measurable picture, avoiding wide
• Any non
• 1. place used patch so that the sticky side covers the shaded area 2. remove backing paper 3. close adhesive label and seal 4. discard with solid waste
• angle distortion in the shaded area, as shown in figure A5.3a.