Some examples and use cases from the internet:

Some examples and use cases from the internet:

• At the emission limit value level, the values of the 95 % confidence intervals of a single measured result shall not exceed the following percentages of the emission limit values:
• The recently published results of the ATLETE testing programme for domestic refrigerators () showed that for 53 % of the tested appliances, information given on the energy labels does not correspond to the measured results.
• The Netherlands, for example, increases the measured result by a factor of 1.33.
• to this end, measurements near nuclear power plants (NPPs) or radiopharmaceutical production plants should be undertaken to show the difference between theoretical release models, reported average releases, and experimental, real measured results.
• This of course has the advantage of being more political and topical but, on the other hand, does not necessarily penetrate very deeply into the world of ABB objectives, performance indicators, and measured results.
• Look, the results are measured in apneic spells per hour.
• At the daily emission limit value level, the values of the 95 % confidence intervals of a single measured result shall not exceed the following percentages of the emission limit values:
• The measured results shall follow the mean curve, plotted using at least 5 speed intervals for Class 1 trains and at least 3 speed intervals for Class 2 trains.

• Where a factor is found to influence the measurement results significantly, conduct further experiments to decide on the acceptability limits of this factor.
• Temperature measurement results shall be recorded automatically and presented in an appropriate fashion to enable the competent authority to verify compliance with the permitted operating conditions referred to in points 1 and 2 in accordance with procedures to be decided upon by the relevant authority.
• The measurement results shall be entered into the test report referred to in the Addendum to Appendix 2 to Annex I.
• The installed overhead contact line shall be accepted if the measurement results comply with the requirements in point 4.2.12.
• Current measurements practice in individual Member States differs too widely and makes it impossible to compare measurement results.
• (b) all measurement results that are used for determination of the physical inventory; and
• The difference between the measurement results shall be small when compared with the MPE.
• A part of a meter that receives the output signals from the measurement transducer(s) and possibly, from associated measuring instruments and displays the measurement results.