Some examples and use cases from the internet:

Some examples and use cases from the internet:

• This list includes Directive 71/316/EEC of 26 July 1971 on the approximation of the laws of the Member States relating to common provisions for both measuring instruments and methods of metrological control.
• The SC warmly welcomes the specific objective no 1, which emphasises measuring both the efficiency and effectiveness of OLAF's operations.
• If both measuring bases are curvilinear in shape despite the requirements of 4.1.3, the effects of centrifugal force must be compensated for by the cross
• 3. The size of each square mesh shall be the width of the gauge at the point where the gauge is stopped when measuring both diagonals in accordance with Article 4.
• The total time t needed to travel along the measuring base in both directions must be determined to an accuracy of 0,7 %.
• Council Directive 71/316/EEC of 26 July 1971 on the approximation of the laws of the Member States relating to common provisions for both measuring instruments and methods of metrological control.
• relating to common provisions for both measuring instruments and methods of metrological control
• section of the bends.

• This list includes Directive 71/316/EEC of 26 July 1971 on the approximation of the laws of the Member States relating to common provisions for both measuring instruments and methods of metrological control.
• Council Directive 71/316/EEC of 26 July 1971 on the approximation of the laws of the Member States relating to common provisions for both measuring instruments and methods of metrological control.
• The SC warmly welcomes the specific objective no 1, which emphasises measuring both the efficiency and effectiveness of OLAF's operations.
• If both measuring bases are curvilinear in shape despite the requirements of 4.1.3, the effects of centrifugal force must be compensated for by the cross
• The total time t needed to travel along the measuring base in both directions must be determined to an accuracy of 0,7 %.
• 3. The size of each square mesh shall be the width of the gauge at the point where the gauge is stopped when measuring both diagonals in accordance with Article 4.
• section of the bends.
• relating to common provisions for both measuring instruments and methods of metrological control