Some examples and use cases from the internet:

Some examples and use cases from the internet:

• 6.3.2.1.1. The maximum intensity (IM) of the driving beam expressed in thousands of candelas shall be calculated by the formula:
• Alternatively, E* may be calculated by the formula:
• The air density shall be calculated by the formula:
• In these formulae, is the mean coefficient of cubical expansion of the liquid between 15 ºC and 50 ºC, i.e. for a maximum variation in temperature of 35 ºC.a is calculated by the formula:
• section are used, the gauge length l shall be calculated by the formula:
• For liquids carried under ambient conditions a could be calculated by the formula:
• This lead the Commission to consider that the State guarantee complied with point 25(d) of the Guidelines, i.e. that the aid was restricted to the amount calculated by the formula set out in the Guidelines' Annex.
• if test pieces of rectangular cross

• it is calculated from the molecular formula (see Annex II.2) and is also expressed as mg oxygen required per mg test compound. ThCO2:
• ThOD Theoretical oxygen demand (mg) is the total amount of oxygen required to oxidise a chemical completely; it is calculated from the molecular formula (see Appendix 2.2) and is also expressed as mg oxygen required per mg test compound.
• P1 is the percentage of clean dry insoluble component as calculated from the formula shown in I..1,
• it is calculated from the molecular formula (see Annex II.) and is also expressed as mg oxygen required per mg test compound. ThCO2:
• Theoretical oxygen demand (mg) is the total amount of oxygen required to oxidise a chemical completely; it is calculated from the molecular formula (see Appendix 2.2) and is also expressed as mg oxygen required per mg test compound.
• ThOD Theoretical oxygen demand (mg) is the total amount of oxygen required to oxidise a chemical completely; it is calculated from the molecular formula (see Appendix 2.2) and is also expressed as mg oxygen required per mg test compound.
• is the percentage of clean dry insoluble component as calculated from the formula shown in I.8.1,
• P1 is the percentage of clean, dry insoluble component as calculated from the formula shown in I.8.1.