- As is shown in greater detail in Chart 2b, in the early 1990s the primary surplus was close to outweighing the sizable debtincreasing effects of a negative growth/ interest rate differential.
- Definition and Requirements for Segments E, F1, F2, and F3 (not shown in Fig. above)
- As is shown in greater detail in Chart 3b, which focuses on changes in deficits, cyclical factors played a major role only in 1993, increasing the deficit.
- On the manikin reproduced in annex 3 to this Regulation, for determining the H point of the seat, the reference line is that shown in fig. 1 in the appendix to that annex;
- Concerning DC systems, the mean contact force Fm formed by the static and aerodynamic components of the contact force with dynamic correction which shall be applied for DC 1,5 kV and DC 3,0 kV systems is shown in fig. 5.2 as a function of running speed.
- As is shown in greater detail in Chart 2b, primary surpluses were generally small and thus not sufficient to outweigh the debt
- Data shall be recorded for the specified base temperature Tb from Table 1 at the location shown in Fig. 5.
- Spot 16 µl of the fixed suspensions onto a clean multitest slide as shown in Fig. 3.
|
- Spot 16 µl of the fixed suspensions onto a clean multitest slide as shown in Fig. 3.
- The brothers Bloom had found their calling, as shown in number six.
- After lashing, a wooden beam shall be placed as a prop against the wheel opposite the weight and secured to the floor so that it is held tightly against the wheel rim during impact as shown in Annex IV, fig. 7.
- Concerning DC systems, the mean contact force Fm formed by the static and aerodynamic components of the contact force with dynamic correction which shall be applied for DC 1,5 kV and DC 3,0 kV systems is shown in fig. 5.2 as a function of running speed.
- Definition and Requirements for Segments E, F1, F2, and F3 (not shown in Fig. above)
- A beam shall be used as a prop for the wheel in the side impact as shown in Annex IV, fig. 7.
- Data shall be recorded for the specified base temperature Tb from Table 1 at the location shown in Fig. 5.
- On the manikin reproduced in annex 3 to this Regulation, for determining the H point of the seat, the reference line is that shown in fig. 1 in the appendix to that annex;
|
